Innovate lm 1 manual

The Innovate Motorsports LM Innovate Motorsports' LM-1 portable wide band oxygen sensor gauge has been on the market for a couple of years now. Its small size, accuracy, simplicity and low price have made it a popular tool with the automobile performance crowd. LC-1 Digital Air/Fuel Ratio (Lambda) Sensor Controller Manual Warning! The Oxygen Sensor used in this device gets very hot in operation. Do not touch the hot sensor. Do not let a hot sensor touch a combustible surface. Do not use the sensor with or near flammable liquids or gases. Failure to heed these warnings may result in severe. The LogWorks installer includes LM Programmer (for modifying or updating hardware), and all Manuals. Manuals: LogWorks 2 Manual LM-1 Manual LM-2 Manual RPM Converter LMA-2 Manual AuxBox - LMA-3 Manual XD Manual LC-1 Manual ST Manual Analog Display Manual Autronic Output Cable Instructions DL Manual SSI-4 Manual TC-4 Manual DB.

About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy Safety How YouTube works Test new features Press Copyright Contact us Creators. 3. 1 MTX-L. The MTX-L is an integrated gauge and controller for wideband AFR (lambda). May 19, Innovate Dlg 1 Air Fuel Ratio Gauge Mustang Install this story, we're going to install a DLG-1 digital air/fuel ratio gauge, with an optional. Single Innovate Device Relay Wiring Instructions.. The PSB-1 is a wideband AFR (lambda) and Boost. the innovate lm2 manual states that the two analog outputs can be used for sensors 12 respectively. Sadly I've tried programming but no luck with this. I have the dual channel kit with all bells and whistles. in the programmer software I'm not able to select sensor 2 (it's greyed out), anyone experience this? My firmware is the latest.

If other Innovate Motorsports devices are going to be daisy-chained along with the SCG-1, it is recommended that all devices be connected to a single ground point, ideally the battery ground (-) post. 3 Connect the LED and momentary pushbutton between the LC-1’s BLACK calibration wire and ground. With the LM-1, precise AFR measurement allows the user to correctly adjust many variables- including carburetor jetting, fuel injection, turbo fuel curves, etc.- without long and expensive dyno sessions. Installing software 1. Double click on the Logworks 3 installer previously downloaded. 2. The installer will start, follow the prompts to install the software. 3. Once the software has been installed the LogWorks software, LM Programmer and MTX-L manual can then be located by navigating through Start-Programs-LogWorks3.